Flooring 450 × 90 × 15.5 mm
Chevron blocks are cut at an angle at both ends in contrast to parquet wood flooring, which has square ends. This creates the classic chevron zig zag pattern running along the floor. This is so popular that it can be found on almost anything; from fabrics and wallpapers to furniture and prints.
The ply backing of an engineered floor with a hardwood veneer glued on top gives our engineered floors the same beautiful appearance of a solid wood floor but with superior construction, greater stability, and compatibility with under floor heating.
Enter your details to calculate your meterage and cost.
Floor Size: 0m2
Extra Margin: 10%
Total Area Required:
Pack Size: 1.13m2
This product can only be purchased in whole packs
Packs: Variable pack size
Our engineered Parquet Woodblock has been produced using WBP birch ply, manufactured to European standard EN 326-2. The adhesive used to bond the board is an E1 category, PUR adhesive (formaldehyde free) to DIN/EN 14257 and DIN/EN 204 low emission glue which is heat and water resistant in accordance with BS EN 14342:2005+A1. The top layer is kiln dried to between 8-12% moisture content.
The formaldehyde emissions are: 0,01 ppm, pentachlorophenol emissions: <0.8 mg/kg.
Thermal conductivity (W/mK) is 0,10W/mK.
Suitable for a fully bonded installation to a screed or ply subfloor, factory Oiled ready to use.
*if the product is being laid in a high traffic environment then an additional coat of oil is recommended.
Compatible for use in conjunction with underfloor heating the woodblock complies with BS 8201:2011, rated in accordance with BS EN 13501-1
Product code: OCOB/450
Profile: Tongue and Groove
Specification: Bevelled Edge
Weight: 11 kg
Recommended Use: Light Domestic
Pack Size: 1.13
Dimensions: 450 × 90 × 15.5 mm
Width: 90 mm
Thickness: 15.5 mm
Length: 450 mm
Colour : Dark
Type of finish : Oiled – An additional coat is recommended.
Unit Measurement : per Square Metre
Design : 15mm Parquet & chevron, Engineered
Micro Bevelled: Micro Bevelled means a very small v shape can be seen on the long sides of the boards. The ends have no bevel.
Pre-Oiled: This product is supplied with a Factory UV Oiled surface. The Natural Wood Floor Company recommends that an additional coat of oil is applied to the surface prior to regular use.
Stick Down: Sticking involves the use of an adhesive to bond the wood flooring to either a concrete/screed sub floor or to a ply/chipboard sub floor.
Under Floor Heating: This product is compatible for use over an electric or water under floor heating system. The maximum temperature must not exceed 27 degrees Celsius at the floor surface.